Application Overview detail drawing PDF Brochure
System III • Waterproofing Lagging Wall
AN EFFECTIVE LAMINATED-DESIGN SYSTEM

Features

• Excellent Structural Integrity – The complete filling of the drainage composite’s dimples eliminates compressive strength concerns.

• Cost Effective – The Material costs and installation speed, make this a high value, quality, and performance solution.

• Complete Positive-side Drainage – The installation of the drainage composite to the total soil surface provides optimum hydrostatic water protection.

• Seamless and Without Voids – The laminated design ensures the drainage composite, membrane, and specially placed concrete are monolithically bonded together as one unit.

• Exceptional for Specially Placed Concrete Application – The irregular surface formed by the drainage composite and the adhesive qualities of the membrane makes the building and bonding of concrete very effective.
The Components:

POSITIVE-SIDE DRAINAGE – ECODRAIN-E

An extremely tough, yet flexible, non-degrading HDPE drainage composite that comes in 8ft x 65.5ft rolls for easy installation and unique dimple design provides a substrate for the liquid membrane.

DETAILING – ECOLINE-R

A fluid- applied, high bonding, rapid cure, water-based material that is used (with fabric) to treat penetrations, transition joints, and seams.

WATERPROOFING – ECOLINE-S

A spray-applied, high-build, water-based monolithic membrane that is a pliable, bonding gasket in the system.

Optional Design:

Ecodrain-S installed in chimney stack fashion with scrim fabric installed behind drainage and soil areas to receive spray membrane.

A.) Soil / Dirt Bank

A.) Soil / Dirt Bank
B.) Shotcrete
C.) Weephole
A.) Soil / Dirt Bank
B.) Drain Mat
C.) Ecoline-S
D.) Shotcrete
A.) Soil / Dirt Bank
B.) Drain Mat
C.) Ecoline-S
D.) Shotcrete
The Installation Steps:

Step 1 – Drainage
• Start from top of grade and attach ECODRAIN-E to soil dig back at the top flange of drainage mat with appropriate nails or spikes.
• Overlap drainage mat six-inches at seams by pulling back filter fabric, applying ECOLINE-R, and snapping dimples together. On horizontal seams top sheet should overlap bottom sheet.
• When earth anchors / soil nails are being used, split drainage mat vertically and slide over the anchor.

Step 2 – Detailing
• Treat all seams on back of drainage mat by applying a coat of ECOLINE-R, embedding fabric 3-inches on each side of seam in it and then applying a second coat.
• Treat all penetrations (including earth anchors) in the same fashion, except applying 6-inches on to the penetration and field with fabric and ECOLINE-R.
• Treat all transition joints (including pylons/piers) in the same fashion including 6-inches on both surfaces.
• Scrim (fabric) must be attached to drainage composite and soil pentration being detailed if optional design is used.

Step 3 – Waterproofing
• Begin the application of ECOLINE-S from the bottom to top.
• Spray application should be done in 4ft x 4ft passes to 20-mil build on each pass.
• One additional pass should be made on all detailed areas to ensure complete coverage and saturation of the fabric.